CUMMINS N14 Specifikace stáhnout pdf (Strana 183)

100

101

NOTE: If the cylinder block is not going to be used imme-

diately, apply a coating of preservative oil to prevent rust.

Cover the block to prevent dirt from sticking to the oil.

Camshaft Bore - Cleaning

Use a fine emery cloth to remove burrs, and clean the

bushing bores.

Camshaft Bore - Inspection

Measure the cylinder block camshaft bore inside diam-

eter.

Camshaft Bore I.D.

mm in

68.237 MIN 2.6865

68.262 MAX 2.6875

If the bore inside diameter is not within specifications, the

bore must be repaired. Refer to the Alternate Repair

Manual, Bulletin No. 3379035.

Main Bearing Bore Alignment - Measurement

NOTE: Service caps do not have the bore machined to a

final specification. If the cap is replaced, the main bearing

bore must be machined. Use the correct parts of the main

bearing boring tool, Part No. ST-1177. Refer to the Alterna-

tive Repair Manual, Bulletin No. 3379035.

Cylinder Block Cylinder Block - Cleaning and Inspection (01-02)

N14 Page 1-15

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 586 587

Komentáře k této Příručce

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Specifikace Strana 183

Komentáře k této Příručce