CUMMINS N14 Specifikace stáhnout pdf (Strana 360)

100

101

Install the spring (4), the washer (3), the valve disc (2), and

the retainer plug (1) into the bore of the locating plate.

NOTE: Make sure the prongs on the disc are down (toward

the washer) and that the cup side of the retainer plug is up

(toward the mandrel).

Install the small end of valve mandrel, Part No. 3376012,

into the bore in the locating plate.

Install the assembly in an arbor press.

Press the mandrel until the large diameter of the mandrel

is against the locating plate.

Remove the assembly from the arbor press.

Remove the mandrel and locating plate from the oil pump

body.

Install a new gasket and the cover to the pump body.

NOTE: Tap the cover lightly with a rubber hammer to push

the cover over the dowels.

Install the capscrews and the washers. Tighten the cap-

screws.

Torque Value: 25 N•m [20 ft-lb]

Turn the gears to make sure they rotate freely.

Lubricating Oil Pump - Rebuild (07-06) Lubricating Oil System

N14Page 7-18

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 586 587

Komentáře k této Příručce

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Specifikace Strana 360

Komentáře k této Příručce