CUMMINS N14 Specifikace stáhnout pdf (Strana 398)

Support the idler pulley in an arbor press. Use bearing

installation tool, Part No. ST-658, to press the bearing

into the pulley until the bearing is against the bottom of

the bearing bore.

Install the retaining ring into the groove in the idler pulley.

NOTE: The flat side of the bearing retaining ring must be

installed toward the bearing.

Push the shaft into the bearing by hand.

Install the flat washer and the capscrew.

Make sure the flat side of the washer is against the bear-

Torque Value: 27 N•m [20 ft-lb]

Water Pump Idler Assembly - Rebuild (08-04) Cooling System

N14Page 8-18

Jesus Morales 03 Apr 2025 | 23:07:31

CUMMINS N14 Specifikace Strana 398